15FT Outboard Throttle Shift Cable GEN II for Mercury Mariner Mount Control 2X

This Outboard Throttle Shift Cable set is a pair of 15-foot Gen II control cables compatible with Mercury and Mariner outboard engines, providing precise throttle and shift control.

Product Overview

This Outboard Throttle Shift Cable set delivers reliable throttle and shift control for Mercury and Mariner outboard engines. Each cable is 15 feet long and built to Generation II specifications, ensuring smooth operation and precise feedback. Designed for replacing worn or seized cables, this pair of outboard throttle shift cables restores full command of your boat’s speed and direction.

Key Features & Performance

• Set of two 15-foot throttle and shift cables
• Gen II design for precise control and reduced backlash
• Compatible with Mercury and Mariner outboard remote control mount systems
• Smooth, low-friction inner core for effortless operation
• Corrosion-resistant outer jacket and stainless steel fittings for marine environments
• Pre-lubricated for long service life and minimal maintenance

Fitment & Compatibility

• Mercury outboard engines equipped with Gen II remote throttle/shift mount control
• Mariner outboard engines equipped with Gen II remote throttle/shift mount control

Common Uses

• Replacing worn or seized throttle/shift cables on Mercury and Mariner outboard boats
• Restoring precise engine control for smooth acceleration and gear changes
• Routine maintenance or repower projects on fishing boats, pontoons, and runabouts
• Use as direct replacement for factory Gen II cables

Technical Specifications

• Quantity: 2 cables
• Length: 15 feet each
• Cable Type: Gen II outboard throttle and shift control cable
• Compatibility: Mercury and Mariner outboard engines with remote mount control
• Inner Core: Smooth, low-friction spiral wound wire
• Outer Jacket: UV and abrasion-resistant PVC
• End Fittings: Standard 10-32 threaded ends (where applicable)

Frequently Asked Questions

Q: Are these cables compatible with my Mercury outboard’s control box? A: These cables are designed for Gen II Mercury and Mariner remote mount control systems. Verify your control box connection type and cable length requirement before ordering.

Q: Do I need any special tools to install these cables? A: Basic hand tools are typically required; routing the cables through the boat and adjusting the barrel nuts is straightforward. Consult your engine service manual for specific routing instructions.

Product appearance and specifications may vary slightly by batch. Compatibility may vary by serial number. Verify fitment before purchase.